CalcTrace

Electricity Cost Calculator

List your appliances with their power in watts, the hours they run each day and the days they are used each year. You get the energy in kilowatt-hours per day, month and year, the cost at the rate you pay, and each appliance’s share of the total.

Last updated .

Appliances

Up to 10 appliances. Rows without watts or hours are left out. An empty “days a year” counts as every day (365).

Your tariff

c/kWh
c/day

The 30 cents is only an example. Enter the usage rate and daily charge from your own bill or plan, with or without tax to match what you want to compare. Leave the supply charge empty to see appliance costs alone.

Result

Cost per year

–kWh per day (average)
–kWh per month
–kWh per year
–Cost per month
    AppliancekWh a yearCost a yearShare
    TotalPer dayPer monthPer year
    Show the working

      How running cost is worked out

      Electricity is sold by energy, not by power. Power, in watts, is the rate at which an appliance uses energy. Energy is power multiplied by time, and the unit on a bill is the kilowatt-hour (kWh): 1,000 watts for one hour. A 2,000 W heater uses 1 kWh in 30 minutes; a 10 W light takes 100 hours to use the same.

      Energy (kWh a year) = W × h × d ÷ 1,000

      Cost a year = kWh a year × rate + supply charge × 365

      W is the appliance’s power in watts, h the hours it runs on a day it is used, and d the number of days a year it is used. Dividing by 1,000 turns watt-hours into kilowatt-hours. The rate is the price per kWh and the supply charge is the fixed daily amount many plans add whatever you use. Monthly figures are a year divided by 12, and the average day is a year divided by 365, so a heater used only in winter is spread across the whole year. Leap years are ignored.

      Worked example: a heater in winter

      1. Energy on a day of use. A 2,000 W heater running 3 hours uses 2,000 × 3 ÷ 1,000 = 6 kWh.
      2. Energy a year. Used on 90 days, that is 6 × 90 = 540 kWh, or 45 kWh a month on average.
      3. Cost. At 30 cents per kWh: 540 × $0.30 = $162.00 a year, or $13.50 a month.
      4. Supply charge. A charge of 100 cents a day adds 365 × $1.00 = $365.00 a year, whether the heater runs or not.

      The calculator starts with that heater, a 100 W television for 4 hours every day (146 kWh, $43.80) and a 60 W laptop for 8 hours on 260 days (124.8 kWh, $37.44). Together they use 810.8 kWh a year and cost $243.24 at 30 cents, of which the heater is 66.6%. That is the pattern in most homes: anything that makes heat, such as heaters, kettles, ovens, dryers and water heaters, dominates, while electronics barely register.

      Finding the right wattage

      The label shows the maximum. The rating plate gives the most power an appliance draws. Many appliances run below it most of the time. A fridge’s compressor switches on and off, a heater’s thermostat cycles once the room is warm, and a computer draws far less at idle than at full load. Using the rating gives an upper estimate.

      Only amps given? Multiply by the supply voltage. For a heater or kettle that gives the power directly. For motors and electronics it overstates the real power, because of the power factor.

      Measure it. A plug-in energy meter shows the actual kWh over a day or a week, which you can divide back into an average.

      Do not forget standby. A device that draws 5 W on standby for 20 hours a day uses 5 × 20 × 365 ÷ 1,000 = 36.5 kWh a year, or $10.95 at 30 cents. Several of them add up.

      What the estimate leaves out

      The calculator applies one flat rate. Plans with time-of-use pricing, tiered blocks, demand charges, solar feed-in credits, discounts, concessions or tax shown separately will produce a bill that differs from these figures. To estimate a time-of-use plan, run the calculator once for each rate period with the hours that fall in it. The result is an estimate for comparing appliances and habits, not a forecast of your bill.